A properly installed vapor barrier blocks ground moisture from reaching your crawl space or basement floor, sealed at every seam and pier.
A vapor barrier installed without properly sealed seams or wrapped piers provides a fraction of the protection it's supposed to, even though it looks complete at a glance. We follow manufacturer overlap and taping specs on every job.
We follow manufacturer overlap and seam-sealing specifications on every install, not shortcuts that look fine until moisture finds the gaps.
Vapor barrier installation is typically a quicker job than full encapsulation, and we can often schedule Jerome, MI appointments within a few days.
Pricing is based on your space's actual square footage and liner thickness selected, quoted in writing before installation.
Under-speccing thickness for a heavily used space is one of the most common installation mistakes we see and correct.
We scope every Vapor Barrier Installation job in person before quoting it, since two properties with the same symptom rarely need the same fix.
We overlap seams per manufacturer spec and seal them with rated tape, not just tucked edges that separate over time.
This is often done in coordination with a flooring contractor's timeline, and we can work around scheduled installation dates.
We use pier boots designed specifically for this purpose rather than improvised wrapping that fails within a year or two.
Existing vapor barriers with failed or separated seams can often be repaired rather than fully replaced, extending the life of a system that's otherwise sound.
We dispose of old material and debris as part of the job, leaving the space ready for the new barrier.
Tell us the square footage, whether it's a crawl space or basement, and how the space is used so we can recommend the right thickness.
We also check for standing water or excessive debris that would need addressing before liner installation.
You'll see the recommended mil thickness, total square footage, and pier wrapping scope broken out with pricing.
Most standard-size installations are completed in a single visit, sealed and ready the same day.
"Old liner in our crawl space was torn and barely covering half the ground. New install with properly sealed seams made an immediate difference in the musty smell."
— Jerome Homeowner
"Recommended a thicker liner since we use the crawl space for storage — made sense once they explained it."
— Jerome Customer
"Seam tape on our old barrier had failed everywhere. They repaired what could be saved instead of pushing a full replacement we didn't need."
— Jerome Homeowner
"Humidity in the crawl space dropped noticeably within days of the new liner going in."
— Jerome Customer
We recommend thickness based on how your specific Jerome, MI space is actually used.
Often yes — if the liner itself is largely intact and only seams have failed, seam repair can extend its life without a full redo.
Yes, pier and post wrapping is included in a proper crawl space vapor barrier installation, since unwrapped supports are a common moisture bypass.
We can scope either depending on your budget and how severe the existing moisture issue is.
Most standard-size crawl spaces or basements are completed in a single visit.
It often helps significantly, especially if ground moisture was the primary source, though persistent odors may point to an additional issue worth investigating.
We install and repair vapor barriers throughout Jerome and the surrounding Jerome, MI service area, including the zip codes listed below.
Zip codes we serve in Jerome, MI: 49249
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
